Elysia skulpter 500

€ 718,00 inc. 21% VAT

Class- A Preamp incl. Soundshaping / Compressor

elysia skulpter 500 is the ultimate recording front end. Its audiophile preamp is based on single resistors controlling a fully discrete Class-A amplifier capable of complementing any microphone with a remarkably true and natural sound.

If additional mojo is needed, two variable saturation/filter stages and an intelligent onboard compressor make voices and instruments sound like a finished record right from the start.

Way more than just a preamp, the elysia skulpter 500 is a complete recording solution – everything you’ll ever need in front of your DAW.

Audiophile Gain Staging
Dual Sound Shaper
Variable Low Cut
Intelligent Onboard Dynamic
Balanced DI
Multifunction Meter
Pure Phase ReverseSignal
Mute Switch
DC Coupled InputPhantom Power
Stepped Controllers
Ground Layer Shield
100% Discrete Class-A Topology

Technical Data

Total gain range
3 – 65 dB in 1.5/2 dB steps

Frequency response
@ 3 dB gain: 10 Hz – 170 kHz (-3 dB)
@ 29 dB gain: 10 Hz – 170 kHz (-3 dB)

THD+N
@ +6 dBu out level, 3 dB gain, 20 Hz – 22k Hz: 0.007%
@ +6 dBu out level, 29 dB gain, 20 Hz – 22 kHz: 0.007%

Noise floor
@ 3 dB gain, 20 Hz – 20 kHz (A-weighted): -97 dBu
@ 29 dB gain, 20 Hz – 20 kHz (A-weighted): -93 dBu

Common Mode Rejection Ratio
@ +6 dBu out level, 29 dBu gain, 1 kHz: 87 dB
@ +6 dBu out level, 29 dBu gain, 10 kHz: 69 dB

Maximum level
Mic Input: 19 dBu
DI Input: 19 dBu
Output: 21 dBu

Impedance
Mic Input: 13.6 kohm
DI Input: 1 megohm
Output: 62 ohm

Power Consumption
Total: 116 mA